UI2000 Digital Electronic Ballast Analyzer is used to test and analyze the input and output electrical characteristics of electronic ballast.
Features:
- Simultaneously display on 8 windows for input and output parameters to convenient for comparing and analysis.
- It can be connected with PC for automatic recording the changing of curve.
- Input and output parameters tested simultaneously within 1 second.
- According to the electronic ballasts in international standards of IEC60929, IEC60969, IEC61000-3-2,GB/T15144-94, GB/T17263-2002
Input characteristics:
- Voltage, Current, Power, PF, Hz, Phasicangle.
- THD (Total Harmonic Distortion) of current and voltage, 0-39th harmonic and harmonic spectrum diagram.
- The actual waveform of current and voltage and the current waveform phase analysis.
- The difference of the lamp current in every successive half-cycle analysis etc.
- Accuracy: ±(0.1% reading + 0.1%range + 1digit)
- Measures the changing and maximum value of input voltage and current in start-up state
Output characteristics:
- Measure the RMS(Root Mean Square) of Lamp Voltage, Lamp Current, Lamp Power, Oscillating Frequency and Crest Factors.
- Accuracy for voltage and current: ±2% Power: ±3%
- Test the peak values and variations of RMS(Root Mean Square) of lamp voltage, lamp voltage, filament current and cathode current from start time to the 5th second.
Startup parameters measurement:
- Measure pre-heat energy and filament pre-heat time, test parameter changing curves of filament voltage, filament current, and filament power from 0 to 5 seconds after startup.
